Quote:
Originally Posted by garden trac 104
hi methos! I have a manual from jensales inc service manual for 72 104 105 124 125 and have clutch and brake pedal linkage adjustments free play clearance etc. I am concerned about the condition of the driving disk pressure plate locating hub and driving plate assembly. I ran on two drive pins last season . I don't think it was put together right to start with . If you want something done right etc q-I know about the throw out bearing and release lever and yoke what about "pilot" bearing Location etc ever hear of anybody welding the broken pin back on the driving plate assembly with sucsess? Got any cost saving words of wisdom. thanks for be'in a pal
|
Only cost savings words of wisdom I can offer is contact Mark IH Cub Cadet Parts. MArk is a site sponser and see what he thinks. I wouldn't trust a welded pin on my cub. If it that weld gives out your looking at more parts to replace and a serious saftey hazard. You might want to post a wanted post in the wanted section of the site looking for a good used part, or contact Patton Acres or Cub Classics via email or phone call.
Having those manuals is huge plus!
Hope this helps.