Jason,
I would remove the hood,most of the wiring to the VR, headlights,and S/G,you will be replacing it all anywho,remove pto turnbuckle,cast grill housing,choke and throttle cables,then remove the 4 bolts holding the motor. Be aware of the orientation of the anti rattle clips when removing the motor,it is best to leave the clutch pedal engaged so the disk does not move on you. The motor should slide right out.There should be a wire clips on the grill housing and next to the right footrest.Remove the debris plate from the bottom of the frame to make it easy to install the new harness.Did I miss anything?
Here is a picture of the fuel line....
__________________
Up to 534 and counting...
I give up updating my profile!
|