Quote:
Originally Posted by Matt G.
That doesn't necessarily mean it's a K301...I think the Magnum single blocks were very similar to the K-series without machining for points. Post a pic of the area where the points would have been on the K-series and we can tell for sure.
The K-series mag ignition still would have used the points. The Magnum does not have points.
|
Machined surface is there but no hole for points rod nor holes for screws to hold points or cover. Maybe Kohler used up K301 inventory on their M12 production?? Or just kept using the 301 block less a couple of machining steps?