[cub149]

OK, I want to hook up a dual spool hydraulic valve BUT I want to do it with two single spool valves. I'm not sure if I will have room for it but I'm going to try since I have two valves laying around. I need to make sure I have the plumbing down correct in my mind so I can mock it up just to see if it is possible.
1)The two ports on the front of the pump, one is a feed line and one is a return, correct?
2)The feed line goes to the "IN" side of the valve, the "OUT" goes back to the pump.
3) Now, to hook up two seperate valves all I would have to do is T into the feed "IN" line and T into the return "OUT" line.

Is my understanding of this correct?