I have been wanting to make some foot pads from diamond plate. I was at a local mom and pop hardware store the other day and found a half sheet of 1/4" aluminum diamond sitting on the floor kinda in the corner. Looked at the price and it said $29.98, I grabbed it and headed to the counter and asked the owner if the price was correct. She said yep it's been back there for a very long time so that's the price. I bought it. Here's the first one, still have to clean up the edges a bit but looks pretty good so far. What do you think Duke?  I'm going to make enough for all my 82 series tractors.
__________________
2013 cub cadet GTX 2100 w/IH weights
1984 cub cadet 1282 w/#2 cart, plow, IH weights
1970 IH cub cadet 73 w/fenders Haban 402d sickle bar
1966 IH cub cadet 102x2
1966 IH cub cadet 71 pull start w/Fenders IH sweeper, Brinly Gard N Cart
1965 IH cub cadet 100 w/Fenders hydro lift Brinly Gard N Cart, 3 point sleeve hitch Brinly plow sleeve hitch blade #1 cart
1965 IH cub cadet 70 w/fenders and snow plow
1961 IH Cub Cadet Original #3646 w/fenders 3 point, IH rear blade, non trip snow plow
|