[QUOTE=cvcman;62814]George, those bearings are 3/4 X 1-5/8" x 1/2 " on epay...How did you get them for 6.00 ?? Just made an offer ?? And these are the same ones my QA42A takes ??
Also do I ned to replace the oil seal ?? Is so where do I get that..
Thx[/QUOTE
---I made him an offer, just like it says.
Those bearings are outer bearings, some gear boxes use a narrower bearing on the inner, some use those and no separate seals.
How would I know if your seals are bad/worn? I'm good, but not that good!
Do they look worn? are they even there? is the shaft rusted where they are installed?
Re read previous replies where to get parts.
Most folks take things apart and see what is needed, then try to make a single order if possible.
This avoids duplicate shipping costs, if ordering from the same supplier.
|