I make my own pullers,just drill two holes in a heavy pice of flat steel and lay it over the shaft(with the nut flush to the shaft)and put the bolts in good and tight into the flywheel,then tap where the shaft is.You need to tighted the bolts a few times,and remove it and put on spacers a few times too,i have always had good success with this method.Also use a lot of PB. 
__________________
149 with kwik-way loader,1772,two 1782 super smokers, 982 SGT w 54" haban blade,60" haban deck, 50in deck cat 0 3 point, brinly cat 0: blade, plow(3), disc.123,hydro lift. 61"O" Brinly single row planter,brinly cultivator,#2 trailer,brinly 10 inch plow,3 42 inch blades,Model #1 Tiller with extenstions,haban sickle mo. 106w/ags and hydro lift.
|