[inspectorudy]

I bought a hydro lift hitch on ebay for a wide frame cub and I cannot figure out how it is supposed to attach to my tractor. I have an 1811 hydro and it has a bunch of holes on the frame rails at the rear but the obvious holes are way too big for the pivot bar to fit in. And the bracket has holes in it that do not match any on my rear cover plate. Can someone please send a picture of you hitch and how it attaches?I figures that any wide frame cub would accept any wide frame hitch. I guess I was wrong. Also, I am going to install an oil pressure gage on my 1811 and was wondering if the sender for the idiot light is just an on/off switch or a true sender. Does anyone know? Also, what is the diameter of the threaded part of the oil switch? I love this beast and would appreciate any help with it. I just found another post with the same question about the exact same hitch. It looks like the one I bought is for an older model and does not fit my 1811. I have a four bolt bottom tranny plate not the three hole model and the picture from the other post shows bushings welded inside of the frame rails that match the diameter of the piviot shaft. Anyone looking for an older wide frame hitch? I would be glad to trade for one that I can use.