Quote:
Originally Posted by william1041200
IH did weld a backing washer to the inside of the spindle to hold the bearings. That is not a PO mod. 3/4 id washers can be bought, and 'machine bushings' can be bought at most hardware stores, that is what I was talking about. Some people feel the need to take up some of the looseness that is necessary.
|
I wasn't saying the factory shoulder was a PO mod, the way I understood the OP was that someone had welded one on over and above this one. Now looking back I can see where he might have thought that was put on by someone. LOL.
__________________
DWayne
1973: 128, ag tires, 3pt. lift, spring assist, lights, 42" Deck
10" moldboard plow
2016 XT1 42" deck 18HP
|