Here are some pics but it was kind of hard to get any kind of decent pic for that area.
CC1450 to answer your question, the label is there for the slack adjustment but painted over. I just can't adjust it to where the manual says it needs to be. Where it is currently it's just shy of the 1st notch on that bar (not shown) yet as you can see I am out of thread on the other pulley and can't adjust it anymore. Is that one pulley supposed to be bent in that far?
When I tried the 80" belt the pulley on the left was up against the axle and no adjusting was moving it. That is an 81" belt on there and it works. I let the pto run for
a little bit. mowed a small 3' path and nothing jumped or shows sign of rubbing yet. I'm just concerned now that after it runs more, it's going to start jumping and I won't be able to tighten the belt anymore.
|