This thing is driving me nuts!
So I put in the new starter, did the carb kit, changed oil and filter plus new spark plugs. I had the all the plastic off of the front end when I did this and I saw what looked like a very bad oil leak. The leak turned out to just be the oil pressure switch so I replaced that also. She fired right up and ran awesome! So I put all the plastic back on and it will only start and run with the choke on. I take off the left side panel to get a look at her don't see any thing wrong I did pull the plug wire off and back on. Then she fires right up and runs great tell I put the side panel back on then she will only run with the chock on. So to get to the point it will only run right with the left side panel off. I checked the wiring but it is all good. I have no clue! Sorry about going on and on but any ideas?