Quote:
Originally Posted by william1041200
I have. Remove that wire, and the solenoid is the bowl nut. Get the bowl out of the way, and clean up the gas in that area. Reconnect wires to the solenoid.
Disconnect sparkplug wire. With key off, solenoid should be extended. Key on should retract the solenoid. It is also spring loaded to extend.
|
Lee250, William is correct except for you need to ground the soenoid to the frame. When grounded the plunger will retract back into the body of the solenoid. Be careful doing this as a spark could ignite any fuel/vapor.