[EricFromPa]

Hi guys/gals

I'm Eric I live in South Central PA,Bedford County to be exact.And I'm a proud owner of a CC127.

I picked this little beauty up last spring.Got her running and used it.
Well after using it for a few months it started to go down hill.Started tapping and noticeable blow-by.As Vapor was poring out of the breather assembly.

So I knew it would need a bit of wrenching to get her back in operation.
I tore into her with high hopes of saving the block but it was to far gone.She was allready .030 over and the cylinder was scored up bad and it was egged out bad enough that the Rings were no longer making contact with the cylinder wall at the bottom of the stroke.

So I found a STD K301a block and had it bored .010 over and bought new piston,rings,rod,bearings and full gasket kit and put her back together.
Threw a bit of paint on the old girl and have been using it as my primary mowing machine for the last 6 months.

Here are a few Pics of when I got it home to as it sits today.