[_DX3_]

Originally Posted by r_nally

Looking to change the hydraulic oil on my recently acquired 1250. I know, Hytran, 7 quarts, I got that part drilled into my head in the little reading I have done.

So three questions
1) Gaskets - What do I need and where can I get them?
2) Filter - what do I need and where can I get it
3) Assuming I find a bunch of gunk when I pull the cover off what is the proper cleaning procedure?
Anything else I should know when doing this is appreciated as well.

1) Gaskets - What do I need and where can I get them?
Rear Cover gasket: Your local dealer or one of our sponsors located at the top of the page.
2) Filter - what do I need and where can I get it
You can get a Hydro filter at your local dealer or NAPA: Here is a link with the numbers: http://www.onlycubcadets.net/forum/showthread.php?t=12
3) Assuming I find a bunch of gunk when I pull the cover off what is the proper cleaning procedure?
Raise the front end higher than the rear to let it drain good, then use some carb cleaner and some lint free paper towels or rags and just reach in and get the goop out.