[QUOTE=Merk;94128]Is the dealer or Kubota blaming gas cap problem on ethanol? It sounds like from Pat's last post over tighting is a the major problem. Another problem is the sealing edge on the fuel tank is not smooth. Did Kubota spec the correct seal/gasket ? Did the company providing the seal/gasket shipped the one Kubota ordered ?
Yup, They have about 20 big sign's hanging all over their show room. Do to high level's of Ethanol we are experiencing problem with our gas cap's. They have been recalled by Kubota and we thank you for your patience's. And it went on from there with a bunch of Blah Blah, please see our service department Blah Blah Blah. I made the mistake of asking the sevice department why it was happening and he went into this big long winded explanation and I listened for about a min. and started looking at new chain saws. So I couldn't tell you more than one word he said. But they are putting the blame on Ethanol. If I'm back down there I'll take a picture of the sign's.
__________________
2013 cub cadet GTX 2100 w/IH weights
1984 cub cadet 1282 w/#2 cart, plow, IH weights
1970 IH cub cadet 73 w/fenders Haban 402d sickle bar
1966 IH cub cadet 102x2
1966 IH cub cadet 71 pull start w/Fenders IH sweeper, Brinly Gard N Cart
1965 IH cub cadet 100 w/Fenders hydro lift Brinly Gard N Cart, 3 point sleeve hitch Brinly plow sleeve hitch blade #1 cart
1965 IH cub cadet 70 w/fenders and snow plow
1961 IH Cub Cadet Original #3646 w/fenders 3 point, IH rear blade, non trip snow plow
|