|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
02-13-2013, 01:12 PM
|
|||
|
|||
Picked up an Engine
I recently picked up a 20hp Kohler Command to go into my 982. Do you guys know of anything to watch out for when putting it in? Will i be able to use the front pro from the onan?
__________________
Cub Cadet 2072 w/ 60" deck Cub Cadet 1872 w/ 50" deck Cub Cadet 682 w/ 44" deck(Blown Motor) Cub Cadet 982 w/ 60" deck 
|
|
#2
02-13-2013, 01:45 PM
|
||||
|
||||
|
Quote:
http://www.onlycubcadets.net/forum/s...ad.php?t=22444 Not sure if you can use your existing PTO. If the shaft size is the same on both engines and the bolt pattern is the same then probably.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#3
02-13-2013, 03:52 PM
|
|||
|
|||
|
Thanks that should help. The pto clutch from the Onan dosent seem to fit. The output shaft on the Onan is about 3" Long and on the Kohler it is only 1". Any ideas or will I need to get a new clutch?
__________________
Cub Cadet 2072 w/ 60" deck Cub Cadet 1872 w/ 50" deck Cub Cadet 682 w/ 44" deck(Blown Motor) Cub Cadet 982 w/ 60" deck
|
|
#4
02-13-2013, 04:34 PM
|
||||
|
||||
|
You may need to sell that PTO and buy one with the same size pulley that will fit your output shaft...
|
|
#5
02-13-2013, 06:22 PM
|
||||
|
||||
|
Quote:
What mods if any to make his fit?
__________________
102-P Narrow tires no creeper--42inch deck and IH blade. 102-D Wide tires,creeper,headlights--42inch deck and CW36 snow thrower. 1997-2086 Super with 3 point hitch and all the bells and whistles. 1961-PTE-"O", needs lots of work. 2072-Repowered with a ch18, Woods tractor. 149 with my Dad. 44" deck and QA36A. #9-70 with weights and sleeve hitch. #10-149 with a 38inch deck. 2015 Kubota BX 2670.
|
|
#6
02-13-2013, 06:51 PM
|
||||
|
||||
|
Quote:
You need to check the shaft length and diameter of that Kohler. If it is only 1" long you are going to have a problem getting a PTO to work on it. Did it come out of a Cub? Most of the Commands are 1” or 1.125” diameter and around 3” long. Not sure but I think most Onans are 1.25” diameter and also about 3” long.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#7
02-13-2013, 07:06 PM
|
|||
|
|||
|
it didn't come out of a cub, the diameter is right but it docent seem to be long enough
__________________
Cub Cadet 2072 w/ 60" deck Cub Cadet 1872 w/ 50" deck Cub Cadet 682 w/ 44" deck(Blown Motor) Cub Cadet 982 w/ 60" deck
|
|
#8
02-13-2013, 07:09 PM
|
||||
|
||||
|
Measure it and take a pic of it and I'll see if I can come up with a way to make it work.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#10
03-01-2013, 10:20 PM
|
|||
|
|||
|
Got the shaft extended and now I'm working on the wiring, the wiring from the onan seems to be completely diffrent
__________________
Cub Cadet 2072 w/ 60" deck Cub Cadet 1872 w/ 50" deck Cub Cadet 682 w/ 44" deck(Blown Motor) Cub Cadet 982 w/ 60" deck
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
