Brinly disk and cultivator parts questions.

[gdheck]

Does anyone know if the new sleeve hitch cultivators use the same shanks as the Category 0 ones used? The ones I need are part #CC-352-10 and the new ones are #C-352-10.

Also, is there a good source for new and used parts for my disk and cultivator? I just got off the phone with Brinly and they were not the least bit helpful.

[64fleetside]

I found Brinly less than helpful also. I made the parts I needed with the help of a buddy..

[gdheck]

After some emails with a guy at Brinly, I can now get the parts I need. I just got off the phone with a lady there and got the parts I needed for my disk and cultivator and the prices weren't too bad. It looks like this is purely a matter of who you talk to when you call. He also told me that some of the older parts were hand made, not automated, and some of them are not available.

For future reference, the guy I exchanged emails with was Shawn Thomas.

[DoubleO7]

Originally Posted by gdheck

After some emails with a guy at Brinly, I can now get the parts I need. I just got off the phone with a lady there and got the parts I needed for my disk and cultivator and the prices weren't too bad. It looks like this is purely a matter of who you talk to when you call. He also told me that some of the older parts were hand made, not automated, and some of them are not available.

For future reference, the guy I exchanged emails with was Shawn Thomas.

That, along with his email address should be a sticky or whatever in the Technical Library - Implements section
for Brinly parts