Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Off Topic > General Talk

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 11-12-2025, 09:55 PM
Oak's Avatar
Oak Oak is offline
Senior Moderator
 
Join Date: Jun 2009
Location: Georgia
Posts: 5,377
Default Got a stuck motor

My dad's Allis Chalmers D17 has been sitting outside for a few years at my place and now the motor is stuck. Last year I dumped some ATF/Acetone down the plug holes but it's still stuck. Tonight I pulled the starter and tried to use a pry bar on the ring gear to move it but got very little if any movement. I did spray some PB down the holes but I need to get some more acetone to go with my ATF.

What if anything have you guys & gals used with good luck on freeing up a stuck motor?
__________________
This ain't no hobby....it's an addiction
Reply With Quote
  #2  
Old 11-12-2025, 10:42 PM
ol'George's Avatar
ol'George ol'George is online now
Grand Member
 
Join Date: Oct 2009
Location: MI
Posts: 6,922
Default

Quote:
Originally Posted by Oak View Post
My dad's Allis Chalmers D17 has been sitting outside for a few years at my place and now the motor is stuck. Last year I dumped some ATF/Acetone down the plug holes but it's still stuck. Tonight I pulled the starter and tried to use a pry bar on the ring gear to move it but got very little if any movement. I did spray some PB down the holes but I need to get some more acetone to go with my ATF.

What if anything have you guys & gals used with good luck on freeing up a stuck motor?
If you got it to move just a bit, that is a wonderful thing as it usually results on it freeing up.
Best to continue moving it both ways and not in the same direction as the back forth movement is much like a tapping operation, turning, then backing up to break the chip.

Bad news is is the engine usually needs to come apart to fix it correctly.
Most times it sets up because water gets into one or more cylinders and that is a bad things that gets worse.
Kroil works well, as does diesel fuel, or 16 to 1, 2 stroke mix. But normally most any penetrating oil works.
I have seen situations where I close the valves (loosing the rocker arms)
then pump a cylinder full of hydraulic oil and using a port-a-power or hydraulics of another tractor to push a piston down,
connecting it through the spark plug hole.
Just some ideas to help.
Oh, and think positive that honestly helps!
Reply With Quote
  #3  
Old 11-13-2025, 05:18 PM
Billy-O's Avatar
Billy-O Billy-O is online now
Grand Member
 
Join Date: Jul 2012
Location: New Jersey
Posts: 1,955
Default

My Dad had a stuck 8N from sitting outside a long time. Managed to free the motor using mystery oil and pry bars. We got it to run, but the gas Ford was big time smoker. Rings were stuck in the piston grooves and cylinder walls were damaged from rust. We were able to do a rebuild with a kit and new sleeves.
__________________
Two 125's and a 124 all with 42" decks
Plow blade
#2 Cart
QA36 snowthower
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:01 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.