![]() |
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
|
I have searched the forums on this subject, it seams when the timing is off these they usually backfire from the carb. My 1650 is backfiring from the exhaust while running and eventually dies. Funny thing is it starts right back up? Any ideas would be appreciated.
|
|
#2
|
||||
|
||||
|
The carb is probably set too lean.
|
|
#3
|
||||
|
||||
|
That and possibly a sticky ex. valve.
__________________
Up to 534 and counting... I give up updating my profile! |
|
#4
|
||||
|
||||
|
Thanks Matt. I will try turning out the Idle air screw.
|
|
#5
|
||||
|
||||
|
turn it in..
__________________
Up to 534 and counting... I give up updating my profile! |
|
#6
|
||||
|
||||
|
|
|
#7
|
||||
|
||||
|
Give it a try and see what the results are.Most times you need to start at a baseline.Here is a chart that shows what yours is.
__________________
Up to 534 and counting... I give up updating my profile! |
|
#8
|
||||
|
||||
|
You need to turn the main screw out, not the idle screw. The idle is adjusted after the main.
|
|
#9
|
||||
|
||||
|
I was looking at my carb and it only has two screws on it, they are both on the side of the carb. Which one is the main screw? On my old JD 112 there were three screws and the main screw was on the top and the idle screws were on the sides.
|
|
#10
|
||||
|
||||
|
If you don't know where they are, look in your Kohler manual. The main screw is the larger one on top, and the idle is at an angle on the right side. If there's one on the body of the carb down towards the bowl, it's a Walbro, and you're probably SOL as far as adjusting it.
|
![]() |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.