|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
12-21-2014, 04:20 PM
|
||||
|
||||
Cross Reference Cub Cadet to NAPA
Here's a list of some stuff I found from NAPA. I think there may be more things. Hope you find this useful.
Cross Reference Cub Cadet to NAPA Tie rod end CCC # 723-3018 NAPA # 7-04231 3/4" wheel bearing IH # 394883R93, NAPA # 7-04292 1" wheel bearing CCC # 741-3002, NAPA # 7-08412 Electronic Voltage Regulator plug NAPA # 7-016008 5 prong ignition switch plug NAPA # 7-016034 Breaker points Kohler # 47-150-03, NAPA # 7-01029 Condenser IH # 62188C1, Kohler # 230722-S, NAPA # 7-01338 Muffler, models 102-149 IH # 393840R91, NAPA # 7-03680 Hydro filter CCC # 723-3014, NAPA # 1084 Hydro filter for auto gear pump CCC # 723-3014, NAPA # 1410 Rear wheel seal CCC # 721-0187, NAPA # 9878 Hydro input seal IH # 394847R91, Sundstrand # 9008000-6201 NAPA # 6204 Hydro trunion seal SN 592014 & below IH # 383534R91 NAPA # 6720 Hydro trunion seal SN 592015 & above Sundstrand # 9008000-6701 NAPA # 6763 PTO bearing, models 70-169 IH # 60071C91 NAPA # RA100RR and PRA100RR (cheaper version) Engine oil filter Kohler 52-050-02-S, NAPA # 1348 Engine oil filter Kohler 12-050-01-S, NAPA # 1056 Shaft seal for Narrow Frame Hydraulic lift pump IH # 347478R91, NAPA # 4911 Sway bar repair kit to replace Quiet Line ISO mount rubbers NAPA # 265-1285 Spark Plug Cross Reference Chart Engine – Kohler K241 (10 HP), K301 (12 HP), K321 (14 HP), K341 (16 HP) Manufacturer and Number ------- Mfgr. Stock Number Champion H10C --------------------- 844 Denso W14L --------- -------------- 6013 NGK B4L ---------------------------- 3112 14mm, 7/16 reach, 13/16 hex. These plugs recommended for stock engines. Engine* – Kohler K241 (10 HP), K301 (12 HP), K321 (14 HP), K341 (16 HP) Champion H8C ------------------------ 587 14mm, 7/16 reach, 13/16 hex. *These are colder heat range plugs for use in modified engines with higher than stock compression ratios. Engine – Kohler K141 (6.25 HP), K161 (7 HP), K181 (8 HP) Champion J8C ------------------------- 841 14mm, 3/8 reach, 13/16 hex. Engine – Kohler KT17 Opposed Twin Champion RV17YC --------------------- 25 14mm, .460 reach, 5/8 hex. Engine – Onan 20 HP Opposed Twin Champion RC14YC --------------------- 431 14mm, 3/4 reach, 5/8 hex.
__________________
Patience is the key to success  . The difficult, I'll do today  . The impossible, I'll do tomorrow 
|
|
#2
09-17-2017, 01:47 PM
|
||||
|
||||
|
Cyclops axle seal
Cyclops wheel seal CCC # 921-3020A National # 474256 SKF # 11930
Source: Oaks thread. http://onlycubcadets.net/forum/showthread.php?t=35077
__________________
Travis 1993 Cub Cadet 2064 1988 Cub Cadet 2072 1980 IH Cub Cadet 782 w/CH20 1966 IH Cub Cadet 102 w/K301 1961 IH Cub Cadet O 1967 IH Cub Cadet 102 & 122     JD 2155 w/ 175 loader
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Hybrid Mode
