|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
11-07-2023, 08:44 PM
|
|||
|
|||
Cub 149 pump shaft - am I doomed?
I had my front pin on my driveshaft shear off this weekend and noticed the pump shaft is pretty hogged out. Does this commonly fail? Is it a nightmare to replace? I found very little info online.
|
|
#2
11-08-2023, 08:56 AM
|
|||
|
|||
|
Not if you can locate a new pump!
Might be time for a replacement and it will be much easier because it looks like the pump has to come completely apart to remove the shaft. Part number for the shaft is SU-3101867 for all the good that will do!
|
|
#3
11-08-2023, 10:21 AM
|
||||
|
||||
|
I have a ported pump out of an 1862. $75.00 plus the shipping. You would need to up grade the drive shaft. I had a 149 that I used part of a 2000 series on the front where it bolts to the engine. I have a 2000 series shaft that you can have for $20.00 if you buy the pump. PM me if you have any questions.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#6
11-09-2023, 07:59 AM
|
||||
|
||||
|
Well they usually don't break off, but they do wallow the coupling bore out if they are worn undersize/loose/sloppy.
Problem is the shafts, if you can find them, are expensive, and if you are not mechanically inclined, and very careful keeping the hydro extremely clean inside the outcome is not the best. Sam has one that I think is more than fair priced and it is a plug and play. Or you can reuse yours and have Sam's spare on hand. Spare parts are always a good thing. 
|
|
#7
11-09-2023, 09:36 AM
|
||||
|
||||
|
302, getting deep into these hydro,s is best to get some odds in your favor. try make a aquaintance with a automatic trans. mech. possibly a enthusaist. hydro ,s are a pressure hydraulic system. It would great a to talk a tractor mech. in teaching some night classes on repair and rebuilds ,until the tractor companies loosen up and start making standard trans. again.
|
|
#9
11-09-2023, 05:49 PM
|
||||
|
||||
|
Down load the service manual for the 149. It covers what you would need to do to replace the shaft.
https://www.onlycubcadets.net/forum/...ead.php?t=4644
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#10
11-09-2023, 05:49 PM
|
||||
|
||||
|
http://www.wfmfiles.com/download/Sau...evB_Jan93).pdf
http://ccmanuals.info/pdf/Sundstrand...e%20Manual.pdf Here are links to the Hyrdo manual that you might find helpful
__________________
Richard 1979 IH Cub Cadet 782 w/CH20, dual hydraulics, power steering and Cat 0 three point
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Hybrid Mode
