Plow skids

[bocephus1991]

Does anyone know,do they make a set of snow plow skids that are poly/heavy plastic instead of metal? Was thinking I saw some but can't remember where? don't like marking up the concrete.

[CaptMax]

Never heard of them, but I would be interested as well if you happen to find any.
CaptMax

[ACecil]

Same here, I need them for my blade.

[camarokidz28]

I am going to try hockey pucks . I will drill a hole in the center and counter sink one side half way and use a carige bolt ,that fits snug and take and round the bottom side a lil on the outside edge . my center hole will be a lil smaler then the square part on the bolt . So it will draw up into the center hole .

[MrGitrdone41]

Xtememotorworks has them. They are metal

[MOturkE]

Originally Posted by camarokidz28

I am going to try hockey pucks . I will drill a hole in the center and counter sink one side half way and use a carige bolt ,that fits snug and take and round the bottom side a lil on the outside edge . my center hole will be a lil smaler then the square part on the bolt . So it will draw up into the center hole .

Good thinkin'...

[CaptMax]

Originally Posted by camarokidz28

I am going to try hockey pucks . I will drill a hole in the center and counter sink one side half way and use a carige bolt ,that fits snug and take and round the bottom side a lil on the outside edge . my center hole will be a lil smaler then the square part on the bolt . So it will draw up into the center hole .

I have another idea along that line. Besides.....have you ever seen a basement wall that a goalie practiced against? You would have black marks all up and down the driveway!!!! I was thinking about using that white material they use for cutting boards in the kitchen, the teflon impregnated stuff. It would hold up even better and not leave "skid" marks. If you make any of these, remember to make extras to sell to all your friends on the board here. I haven't checked on the material yet, too many projects and so little time.
CaptMax

[bocephus1991]

Thanks guys,I like the idea of making some pads out of the white cutting board material. We used that on work benches at my old job and that stuff is tough as nails. Will have to look into it,thanks alot for all the input!

[green 4 acres]

my 10xl sears gt has a awsome snow blade that I will adapt to the 128 , it pivots left to right letting you plow through heavyer snow-- It has steel skids -- In 20 years of use I have not marred the drive -- unless the blade hit it -- it seems to glide on the skids remember also the concrete is frozen and icy or wet 4130 might work even better as hard to grab


128

[ol'George]

I used a broken leaf from a truck spring
They are about 2-1/2" wide and maybe 3/8" thick.
I just bent them up @ a 45* angle on each end (using a torch) and welded them to the worn out skids on the Qa42 thrower
I'm sure they will outlast me!
cheap,easy, works great, and they wear like plow shares!