![]() |
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
||||
|
||||
|
I want to get the flywheel off but I first need to get the yellow pulley that attaches to the clutch driver off that is pictured before I can get to the threaded hole to pull the flywheel. How do I do this? I have already pulled the flywheel nut so.... I'm at a loss any help would be appreciated! Thanks in advance. Also where would be a good place to get a new pulley seeing as how that one is chipped?
|
|
#2
|
||||
|
||||
|
I usualy use a rubber mallet and tap it side to side. Usualy comes off. Its chipped more then likely cuz someone pried on it or hit it
__________________
No more cubs. But never fear there will be more ![]() ![]() ![]()
|
|
#3
|
||||
|
||||
|
I agree with cubby102
If you have already taken the nut off, it should come loose. |
|
#4
|
||||
|
||||
|
Do you think that it may be reusable or not with that piece missing?
|
|
#5
|
||||
|
||||
|
Ive used them like that but check it out make sure itd not cracked anywhere else. It is a possibilty for chunks to come flying off. Clean it up and inspect it
__________________
No more cubs. But never fear there will be more ![]() ![]() ![]()
|
|
#6
|
|||
|
|||
|
Quote:
![]() If you replace it, box up that one and send it to me.... I'll use it. I'm not scared.
|
|
#7
|
||||
|
||||
|
Well back to the how do I get it off? I'd put a puller on it with some heat and it should come off. Most of the time they stick on the dowel pin.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
![]() |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.