|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
07-05-2013, 09:42 PM
|
||||
|
||||
A Thank You Is In Order
As a newer Cub owner who religiously checks these posts daily (even before checking the news), not only have you taught me a lot about my machine but also about Cubs in general - and it's been a heck of an education over the last year. And you all have saved me a lot of Benjamins in the process. For someone who is not a Tech, owning an old machine (which is a gambit to begin with) and never having to have to bring it to a dealer to fix things is a hoot. (I couldn't anyways as I don't own a trailer) For example, when the tab broke off from one of my fragile plastic engine shields, I thought I was looking at $180+ plus for a new shield. Then after some research here I found the solution - JB Weld. At $5.95 it worked wonders...and the shield is fixed.
Then the Amp light went on...and stayed on under full load. Well, $79 for a new battery I guess. Then after some research, I then cleaned every electrical contact and every blasted wire...and voila, no lit Amp light (Sam Mac IS THE MAN)! Then there was the brakes, and the rough idle and the leak from the front of the engine and on and on and on. Yet I have resolved them all and although I may have learned a lot in college, the OCC Continuing Education program here has taught me quite a bit. A few of them are as follows: • Use Seafoam/MMO in the gas • The mystery of the 14/16HP B+S Vanguard • P B Blaster smokes WD-40 • Always check the service manual first • Patience • Don't guess - figure it out • Don't cut corners...unless you want to do it again • Check the service manual again • Have replacement parts ready BEFORE you take everything apart • Hi-lift CC blades are light years better than Flat CC blades • When they say use Hi-Tran Fluid, they mean Hi-Tran Fluid • Where the great yards and parts are: Patton Acres, IHCCW, Houtz, Messicks, Maple Hunter • Never ever scrimp on the quality of grease • Never spray parts on the machine, take the part off and do it right • The secret to rattle cans of power coat paint - never shake up and down (clogs spray head) just roll the rattlers around on the bottom around and around • Shooting Gumout in the carb is NOT cleaning the carb • Keep the engine fins clean • Never wash the mower deck, use a leaf blower • Don't forget the Zerks on the Drive Shaft • When something starts leaking, don't postpone the inevitable • JB Weld is a miracle • If you are going to take it apart -get the camera! • Electrical/fuel problems are the gremlins, check the wires/connections and fuel delivery first • You guys DO have all the answers! Many thanks, ccguy 1994-1440 
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Threaded Mode