|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#11
12-02-2012, 01:14 PM
|
||||
|
||||
That's a really nice fabrication! Great work! I could use one too!
Regards, Chris
__________________
Casbohm Maple and Honey www.mapleandhoney.com Cubs: 147R and the "train", 127 elec lift, 127, 125, 106, 102, 100, 86, 73, Brinly plow, Snow thrower, 2 Rototillers, several mower decks and several snow plows, #1 cart, Grandkids barrel cart. 
|
|
#12
12-04-2012, 03:35 PM
|
|||
|
|||
|
thats next on my build list. maybe instead of getting rid of the casters, you could build little boxes around the top of them, almost like a shield. im guessing those casters make rolling that table around a dream, i wouldn't wanna get rid of them. but shields on the top and all four sides would prevent any falling slag or molten metal from contacting the top of the casters. sheet metal would work great for that.
|
|
#13
12-29-2012, 10:13 PM
|
||||
|
||||
|
I finally got time to get the receiver cut into the table. I decided to go thru the top itself.
I cut a square hole just large enough to allow the outside of the receiver to go thru.  I welded a 5/8 nut over the pin hole for a "tightening bolt". Then welded the receiver in place. I left it about 3/16" below the surface. I made a removable plug out of 3/16" steel to cover the opening if nothing is in the receiver.  I used 1/2" thick plate to make the vise mount. Drilled and tapped it for 1/2" bolts.  Welded a 2" tube to the bottom...  Bolted the vise ( My Christmas present  ) to the plate....  Also made an anvil out of an old rail..   Next up will be mounts for a grinder and buffer.
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
