PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Ok, Ill try new battery and battery cables. I'll report back if it works now or still having no start issues.
|
#12
|
||||
|
||||
It won't hurt to replace the cables with a larger size and run a ground straight from the battery to the engine block, ask me how I know.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
#13
|
|||
|
|||
Ok, Right now the ground is under seat and bolts to frame next to battery. All I have is 4 or 6 gauge battery cable.
|
#14
|
||||
|
||||
Run the largest stuff you have. Crappy grounds are one of the most common issues with Cubs. Look through some of the other hard to start threads that have been posted this year. When I do one I use welding cable and I solder the ends on. You can pick it up at Tractor Supply.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
#15
|
||||
|
||||
Quote:
I have a 782/KT17 with a no-start (but used to) so I'm following this thread closely. I'm starting with a better ground.
__________________
Current: 102 122 SZ60 Past: Original 71 72 73 86 100 102 122 123 124 125 127 129 147 149 169 383 582 682 782 782D 784 982 1000 1050 1100 1200 1210 1250 1415 1420 1440 1450 1535 1641 1650 1710 1711 1730 1806 1810 1811 1860 1861 1862 1863 1864 1882 3185 3205 7265 |
#16
|
||||
|
||||
Soldering cables is easy, you cut small pieces of solder off inside the lug and fill every gap with them, heat the lug with a torch until solder boils, stick the stripped cable into the boiling solder and let it cool for a minute while holding it. Then heat shrink and done, works every time. Always good to wear big gloves and do it out in front of you, in case some solder comes out when you put cable in.
__________________
(2) Original, 100, 102, 124, 73, 800, #1 and #2 cart, brinly plows, disk, IH184, IH244, 1948 F Cub |
#17
|
|||
|
|||
Thanks for info on soidering battery cables together. I have the HF hydaulic battery cable crimper. It can do 0-14 gauge battery cable.
|
#18
|
||||
|
||||
Crimp is OK but solder is better. I just put the terminal end in the vise, heat it with a propane torch, melt rosin core solder into it the slip the cable into the molten solder, heat it a little while longer to get the solder into the cable strands then let it cool. Heat shrink and your done.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.