Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > Cub Cadet Engines

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 12-22-2015, 07:53 PM
rocker582special's Avatar
rocker582special rocker582special is offline
Senior Member
 
Join Date: Feb 2013
Location: Ohio
Posts: 359
Default 13hp Kohler ohv in a 682

Hello just curious if a 13 Kohler ohv will fit in a 682? The engine came out of a cub cadet but I'm curious if it would fit in an 82 series cub cadet. Thank you for information.
Reply With Quote
  #2  
Old 12-22-2015, 09:42 PM
dvogtvpe's Avatar
dvogtvpe dvogtvpe is offline
Grand Member
 
Join Date: Oct 2011
Location: Campbellsport Wisconsin
Posts: 1,585
Default

You can make just about anything can fit. It's the tools and money you have to work with and fabrication talent, that is usually the hard part.
Reply With Quote
  #3  
Old 12-23-2015, 09:21 AM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
 
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default

It should fit but it's not going to be a bolt in. You'll need to figure out the drive shaft, muffler, duct work, wiring and PTO. I'd start by setting the engine on the motor plate so that the belt for the mule drive lines up properly with the mule drive and work from that point. Get your drive shaft lined up to the pump so that it is as close to being in line with the pump as possible. If you have the drive shaft that came out of the donor (I'm guessing it was something like a 2130) then you can use some of it to couple the engine to your existing shaft. Did that on a 149 here is a pic. Most of the 2000 series shafts have a 5/8" ID so the solid shaft used in most of the 82 series will slip inside (makes it easy to get the proper length) then you just drill a 1/4" hole through it and put a spirol pin in and your done.
Attached Images
File Type: jpg IMG_3559.jpg (25.7 KB, 108 views)
File Type: jpg IMG_3555.jpg (20.3 KB, 106 views)
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:28 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.