Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #11  
Old 10-26-2020, 09:56 PM
drglinski's Avatar
drglinski drglinski is offline
Grand Member
 
Join Date: May 2012
Location: Michigan
Posts: 3,939
Default

I have the carlisle 4 rib tires on my 147 and the only time I have an issue with the steering on it was when 1) pushing snow and it would fall off the concrete edge of the driveway it didn't want to steer back onto it and 2) plowing (dirt) and wanted to drive out of the furrow it had a tendency to roll along the edge of said furrow. It did eventually grab and pull itself out. Other than that I like them. I keep 25 LBS in them to help the balloon a bit so they steer easier.
__________________
Daniel G.




.

(May 1970) 147 w/an IH spring assist, 48" deck, 42" blade, 1969 73, #2 trailer, 10" Brinly plow and (on loan) Dad's #2 tiller.
Reply With Quote
  #12  
Old 10-29-2020, 08:33 AM
jbrewer's Avatar
jbrewer jbrewer is offline
Grand Member
 
Join Date: Sep 2011
Location: NC
Posts: 2,556
Default

Quote:
Originally Posted by Cub Cadet 123 View Post
I've had great luck with the skinnies tri-ribs on the front.
Cub Cadet 123



I'm going to have to try this on one of the cubs.

Skinny and tall is the secret to easy steering. I put a set of what looks to be small trailer tires on the front of my O and they've been fantastic (and cheap) for years now . Super easy to steer and they're fine on the lawn. I imagine the ribbed tires would be the same.


I had a 70 SS396 Chevelle with no power steering. With short fat , 60's series front tires, it was wrestling match to steer at low speeds. Fortunately I rarely drove it at low speeds....
__________________
61 and 63 Originals
123 (2)
782D
106,
147, 122
102
parts

It's only original ONCE!
Reply With Quote
  #13  
Old 10-29-2020, 02:40 PM
dbuck dbuck is offline
Senior Member
 
Join Date: Jun 2009
Location: Indiana
Posts: 639
Talking

I have a set of firestone 3 ribs on the front of my 149, makes the tractor turn like power steering.
__________________
Don B, USAF 1962-1968, Ft. Wayne, IN
Reply With Quote
  #14  
Old 10-29-2020, 03:01 PM
ol'George's Avatar
ol'George ol'George is offline
Grand Member
 
Join Date: Oct 2009
Location: MI
Posts: 6,693
Default

We have gotten spoiled with power steering now a days.
In my day, most everything was Armstrong steering and one didn't try to turn the steering wheel unless the vehicle was moving a bit.
We learned it quickly and it really was not that bad, but to go back to it after having one finger power assist in todays world with vehicle at rest, is quite an undertaking and a wake up call to most young folks.
Just like there are folks that never drove a manual transmission let alone one you had to double clutch.
The "good old days" in some ways lacked some nice features we take for granted today,like electric windshield wipers, power windows and power brakes.
Hell, Radio and heater were optional, and turn signals didn't become standard till the middle 50's,--- about the time hydraulic lifters became standard equipment.
Try driving up a slight incline with Vacuum operated wipers on a rainy day or snow/icy conditions without heater/defroster, ya rolled the window down and stuck your head out to see or signaled for a turn with your hand/arm.
---enough rambling.
Reply With Quote
  #15  
Old 10-30-2020, 09:43 PM
drglinski's Avatar
drglinski drglinski is offline
Grand Member
 
Join Date: May 2012
Location: Michigan
Posts: 3,939
Default

Quote:
Originally Posted by ol'George View Post
We have gotten spoiled with power steering now a days.
In my day, most everything was Armstrong steering and one didn't try to turn the steering wheel unless the vehicle was moving a bit.
We learned it quickly and it really was not that bad, but to go back to it after having one finger power assist in todays world with vehicle at rest, is quite an undertaking and a wake up call to most young folks.
Just like there are folks that never drove a manual transmission let alone one you had to double clutch.
The "good old days" in some ways lacked some nice features we take for granted today,like electric windshield wipers, power windows and power brakes.
Hell, Radio and heater were optional, and turn signals didn't become standard till the middle 50's,--- about the time hydraulic lifters became standard equipment.
Try driving up a slight incline with Vacuum operated wipers on a rainy day or snow/icy conditions without heater/defroster, ya rolled the window down and stuck your head out to see or signaled for a turn with your hand/arm.
---enough rambling.

I'd love to have a vehicle that was simple, easy and cheap to repair, and just work. Too many regulations and electronics on today's vehicles.



I have a set of the narrow tri ribs on the front of my 73. They steer great when I don't have a snow blade on. With the blade they do fine. Looks good on the lower HP cubs but those that have the wide fenders (wide frames) it looks silly.
__________________
Daniel G.




.

(May 1970) 147 w/an IH spring assist, 48" deck, 42" blade, 1969 73, #2 trailer, 10" Brinly plow and (on loan) Dad's #2 tiller.
Reply With Quote
  #16  
Old 10-31-2020, 12:41 PM
SGragg SGragg is offline
Senior Member
 
Join Date: Jul 2012
Location: MO
Posts: 748
Default

Ok, ordered a set of Vredestein V61s from Miller Tire on Wednesday, the 28th. Had new tires and tubes sitting on my front door step on Friday, the 30th.

Tires were not compressed and looked to be fully expanded, ready to install. Got both of them on the rims in 20 minutes or less. I like how they look.

After installing them, I thought they looked a little too canted, but took a drive and WOW! they hold a line across the yard; even in bumpy places. Steer with one finger, just like power steering. I was originally searching for tires that held true to a line when moving. Think these will do fine. The grass was wet and there was not slippage from the new rear tires either.
Attached Images
File Type: jpg DSCN2777.jpg (19.3 KB, 54 views)
File Type: jpg DSCN2778.jpg (22.1 KB, 54 views)
File Type: jpg DSCN2782.jpg (24.8 KB, 54 views)
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:06 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.