Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > Cub Cadet Engines > Kohler Engines
Reload this Page K series oil seals and ignition timing questions
Register FAQ Calendar

Notices

Reply
Page 2 of 2 1 2
 
Thread Tools Display Modes
  #11  
Old 06-21-2021, 10:03 PM
Cubcadet_107's Avatar
Cubcadet_107 Cubcadet_107 is offline
Senior Member
  
Join Date: Sep 2018
Location: New York
Posts: 571
Default
Quote:
Originally Posted by ol'George View Post
Hope the seal works for you.
Most times reinstalling a seal does not go well, as they conform to the bore by
being squeezed just a bit and during a reinstall, they are just a bit smaller/looser.
----sometimes one gets lucky tho'
ya win some, loose some.
Well George, I guess I did get lucky with reinstalling the seal then, I've run the engine for quite a while now and it's holding up just fine. It's only temporary until I get the chance to buy a new seal.

I will say that installing it certainly took much more force to install than it took to install that metric one!
__________________

'70 107 with k301 engine swap
'71 106 with 38" deck
'70 147R with factory replacement k321, 42" deck
'61 Original with 38" timed deck
'63 70 "pinkie"
1863 with 54" deck
'46 Farmall H, '50 Farmall Cub

105 x2 (parts)
Reply With Quote
  #12  
Old 06-22-2021, 12:28 AM
ol'George's Avatar
ol'George ol'George is offline
Grand Member
  
Join Date: Oct 2009
Location: MI
Posts: 6,693
Default
Quote:
Originally Posted by Cubcadet_107 View Post
Well George, I guess I did get lucky with reinstalling the seal then, I've run the engine for quite a while now and it's holding up just fine. It's only temporary until I get the chance to buy a new seal.

I will say that installing it certainly took much more force to install than it took to install that metric one!
If it drove in tight, that is a good thing!
Tight is always good, I'd leave it alone if it don't leak.
And you now learned what a loose fit causes.
Reply With Quote
Reply
Page 2 of 2 1 2

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 10:46 PM.

www.onlycubcadets.net - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.