Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > Cub Cadet Engines > Kubota Engines

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 05-02-2015, 03:58 PM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
 
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default 2182 Partial throttle surge.

2182 Partial throttle surge issue. Well after 3 years I finally found out what has been causing the surge in my 2182. It would idle fine and run wide open but at just a bit over idle it had a horrible surge. Funny thing is only one of my 2182's was doing this. I've even replaced the carb. Today I was working on the last one I picked up because it had a low power problem that turned out to be a governor that was way out of whack, fixed that and it made it run like a new one. So I figured I should check the other one, it needed a little adjustment. Anyway while I had it running with the side cover off I noticed that the spring that connects the throttle linage to the governor was vibrating and the engine was surging, put my finger against it to stop the vibration and the surging stoped. You have got to be kidding me! Unhooked the spring, put a half twist in it and end of problem.

Procedure for adjusting the governor is super simple. With the engine off set the throttle at wide open so that the carb is fully open. Loosen the nut on the governor control and with a flat blade screw driver turn the governor shaft fully clockwise looking at it from the top. Hold the governor shaft and tighten the nut back up. You'll need a 12mm wrench for the nut.
Attached Images
File Type: jpg IMG_3979.jpg (28.1 KB, 515 views)
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #2  
Old 05-02-2015, 05:56 PM
raytasch raytasch is offline
Senior Member
 
Join Date: Feb 2015
Location: West central FL
Posts: 104
Default

I must file that away in the unusual problems/fixes section of the brain. Vibrations can give unusual problems. Just ask any rotary wind aircraft mechanic.
__________________
122 original, well used. Owned since 1972
2182 new to me. Refurbished and gave to my son.
Deere 4300 4WDA HST with FEL
Many old Ford tractors, all gone now
Couple old Ford trucks
Reply With Quote
  #3  
Old 05-02-2015, 07:22 PM
Andy2182's Avatar
Andy2182 Andy2182 is offline
Member
 
Join Date: Jun 2014
Location: Franklin Pennsylvania
Posts: 80
Default

Hey Sam, put this link in the page of links that you send to everyone. I haven't had a gasser out yet this year to try this but it makes sense. Been playing with the diesels. Thanks for continually tinkering with these Sam!
Reply With Quote
  #4  
Old 03-12-2021, 03:17 AM
Bryan S Bryan S is offline
Senior Member
 
Join Date: Nov 2020
Location: Lancaster, PA
Posts: 159
Default

Quote:
Originally Posted by Sam Mac View Post
2182 Partial throttle surge issue. Well after 3 years

Anyway while I had it running with the side cover off I noticed that the spring that connects the throttle linage to the governor was vibrating and the engine was surging, put my finger against it to stop the vibration and the surging stoped. You have got to be kidding me!
Before anybody says that you know this thread is almost 6 years old?
Why Yes, Yes I do.
I found this thread last fall and finally got around to trying the finger on the spring thing. YEP! sure enough the surge stopped.
I have had this same issue with my 2182, for way longer
than 3 years, very irritating/frustrating, as Sam mentioned.
But I wanted to first and foremost, thank Sam for posting this.
And second, bring this threadout from the weeds, in the hope that it might help somebody else out.
__________________
The Cub Pack. 70, 100 (creeper), 104, 122 (2), 1250, 1810, 1863, 2182, LTX 1050, SLTX 1050, SLT 1550, SLT 1554, Snow Chuckers 450, 451, 826T, 1030E, 2 plow blades. always looking for "just one more"
Reply With Quote
  #5  
Old 03-12-2021, 06:47 PM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
 
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default

Glad to help.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #6  
Old 03-14-2021, 04:30 AM
Bryan S Bryan S is offline
Senior Member
 
Join Date: Nov 2020
Location: Lancaster, PA
Posts: 159
Default

Sam, what's really odd is I didn't do anything,
other than I put my index finger on the spring,
which was vibrating violently, and when I did,
the spring turned a little bit and the surging stopped.
Spring still vibrating so...
Fired it up today, and drove it down to the neighbor's
house and no surging while sitting there talking to him for a few.
Just a real head
__________________
The Cub Pack. 70, 100 (creeper), 104, 122 (2), 1250, 1810, 1863, 2182, LTX 1050, SLTX 1050, SLT 1550, SLT 1554, Snow Chuckers 450, 451, 826T, 1030E, 2 plow blades. always looking for "just one more"
Reply With Quote
  #7  
Old 03-01-2022, 02:47 PM
malchren's Avatar
malchren malchren is offline
Senior Member
 
Join Date: Aug 2013
Location: CT
Posts: 155
Default

mine does the same thing. going to have to try this after work and see if its the same issue.
__________________
Collection so far,
CC 102 (owned since I was 12)
CC 73 (roller that i need to eventually started on)
CC 106 (nice clean older resto)
CC 107 (Clean original unit used as backup mower)
CC 126 (snow removal, one owner)
CC 127 (lightly built engine, primary mower)
CC 147 (with sweepster broom)
CC 1650 (Dual hydro option on both other has k361)
CC 169 (needs paint now)
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:08 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.