PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CV730S advice
I put a CV730S into my LT1042, which previously had a CV491S. I added a net-new choke cable and also installed a longer throttle cable but for the life of me I cannot figure out how to route these cables and where they are to be connected. In general, I know which lever (on the front of the engine) to connect the choke cable to and which lever to connect the throttle cable to, but what I do not know is, does the choke cable come from the dash and around the left side (from the seat perspective) of the engine and into the lower portion of the choke lever? or the higher position on the choke lever? Same for the throttle cable...does it route around the right side of the engine (from the seat perspective) and connect to the throttle lever on the higher part of the lever? or the lower part? It's driving me bananas that I can't find any documentation for this.
If you choose to respond, please explain it to me like I'm five years old. I can follow instructions, but this is not my area of expertise, it's not even my area of "intermediate experience"...I'm just a guy who dorked the original engine, learned (an expensive) lesson, and is trying desperately to not buy a new lawn tractor. |
#2
|
|||
|
|||
First, welcome to OCC........
It is impossible to vision what you are talking about, without any pictures. Generally speaking, ....IF..... your cables are long enough, re-routing is most likely your solution. If re-routing is not possible, either auxiliary linkages or longer cables may have to be sought.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1: |
#3
|
|||
|
|||
Pictures.....
I've attached some picture that may make things more clear.....or not.
|
#4
|
||||
|
||||
I have this picture which was of a Craftsman.
The cables came in from the right and were attached as you have them, but the exhaust system appears to be a little different. |
#5
|
||||
|
||||
OP, your 3rd Posted picture looks correct.
The cables can be routed in either side. The top cable should go to the choke the lower cable to the throttle. Which they appear to be doing. Ironman, your picture is of an older craftsman with side mounted muffler. That engine also looks like it is set up for single combined throttle/choke cable.
__________________
JD x475 |
#6
|
||||
|
||||
It did have a separate choke cable, it was not connected in the engine picture.
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.