Changing blades on tractor

[Ozcub]

Originally Posted by ironman

to Brits, shifting spanner = adjustable wrench.

That is correct , A Shifting spanner or a shifter for short is an adjustable spanner

(Quote+finsruskw) To me, that would be a last resort!
Good way to bust some knuckles and round off the corners of the nut!

Never had that problem of rounding off nuts
However the mistake is I am an Australian not a Brit
Also to clarify a recent post about an American screwdriver to us Aussies that is a "Hammer"
No offense is taken or given
Oz

[Sam Mac]

Originally Posted by ol'George

3/4" drive Ingersoll with #150 air line should "ger er done" quicker than you can lick ice cream off your shirt on a *100 summer day

My 1/2" IR with 125 PSI has always been enough and it's only 35 years old.

[ironman]

Originally Posted by Ozcub

That is correct , A Shifting spanner or a shifter for short is an adjustable spanner

(Quote+finsruskw) To me, that would be a last resort!
Good way to bust some knuckles and round off the corners of the nut!

Never had that problem of rounding off nuts
However the mistake is I am an Australian not a Brit
Also to clarify a recent post about an American screwdriver to us Aussies that is a "Hammer"
No offense is taken or given
Oz

Just to clarify;
It is a British term and you speak English and used it.
So where did I say you are a Brit?
No offense is taken or given.

[guybb3]

Originally Posted by Red Dave

If I were you, I'd be using an impact gun.

But then, I've been using an impact gun on mower blades for many years. Between running, grass juice and corrosion those nuts can get very tight.

Just don't over tighten with the impact when you put them back on. Just make them tight and stop.

One other thing I've been doing since back in the 1960's, is to put a dab of Neversieze on the threads before putting blades back on. Just a dab, don't overdo it or that stuff gets everywhere.

Perfect advice. Sometimes I use Mobil 1 grease for never seize as well.