PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#141
|
||||
|
||||
Quote:
__________________
|
#142
|
||||
|
||||
Quote:
__________________
|
#143
|
|||
|
|||
The pump would by pass from pressure side to "suction" side and overheat. Plus noise and very poor performance. The notches are there for pressure relief at the end of each piston's pressure cycle. If it were possible to have pump plates notched on both sides, manufacturers would do it to save inventory costs. It may exist, but I don't recall ever seeing any.
Left hand plates should be available, but to find a dealer that would bother to find one is the problem. This same pump size and series is used in Sundstrand pumps for many close loop systems, not just hydro's. If I had one in pieces, I could likely get it matched to a series. Might find that info on Google to. I'll search around a bit tomorrow. If you google Sundstrand 15 series, you'll see examples of the the hydro units and closed loop but separate pump/motors transmissions. Same parts in a different package. These hydro's were used in a lot of smaller equipment like sweepers, airport equipment, swathers and the like. |
#144
|
||||
|
||||
Quote:
__________________
|
#145
|
|||
|
|||
I think one of your major engineering puzzles might be being able to keep tension in your tracks. Some how your axles will have to adjust away from each other and still be driven by a common shaft. Track machines power from the same end, whereas yours will be slack on top on one side and slack on the bottom in the other.
|
#146
|
||||
|
||||
Quote:
__________________
'70 107 with k301 engine swap '71 106 with 38" deck '70 147R with factory replacement k321, 42" deck '61 Original with 38" timed deck '63 70 "pinkie" 1863 with 54" deck '46 Farmall H, '50 Farmall Cub 105 x2 (parts) |
#147
|
||||
|
||||
Quote:
__________________
|
#148
|
|||
|
|||
A mini Hi-Drive! That would be cool.
|
#149
|
|||
|
|||
Quote:
Something that comes to mind though is you could swap the ring gear to change the travel but to cure the direction of the input issue you could consider a jack shaft from the rear drive shaft up the the front rear. That way the pump would be turning the proper direction. |
#150
|
||||
|
||||
Quote:
I'm going to start another thread on mini-dozer build. Let's take this discussion over there.
__________________
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.