PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Yes but we don't, the chunks of paint that come off like to clog the tip when it's reused
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965 |
#12
|
||||
|
||||
you should put a sifter thingy on the bottom of the cabinet to catch the debris.
__________________
Up to 530 and counting... I give up updating my profile! |
#13
|
||||
|
||||
I'm Mr. Small time compared to you experts, but I like the Black Diamond. I blast on the cement driveway, then sweep it up and screen it back into the blaster. Reuse it three times, then in becomes part of the gravel driveway.
To the OP. I would be causes blasting around the differential, stuff get's in everywhere, and hard to get it all back out. I do not blast anything that will have oil in it. Diff, or engine...
__________________
Make the best of each day , Todd Original's Face Lift thread.http://www.onlycubcadets.net/forum/s...ad.php?t=34439 (O) Start to Finish video.https://www.youtube.com/watch?v=GAoUNNiLwKs Wheel Around videohttps://www.youtube.com/watch?v=XUL-m6Bramk They can't all be turn key! |
#14
|
||||
|
||||
we use glass beads in the cabinet, the silica sand gets used for the big stiff. we have a 12x16 building we blast all the tractor parts in, the blaster holds 100lbs and is powered by two big screw compressors. we've tried sifting it but its so time consuming that its not economical.
__________________
Tim Pap's 100 Restored 108 1211 Dual Stick 1050 Pap's 100 restoration thread - http://onlycubcadets.net/forum/showthread.php?t=47965 |
#15
|
|||
|
|||
Hey Zippy brought up a good point, how do you clean/strip the rearend and hydro housings? I was leary about having them blasted due to the openings and having the abrasive remianing inside.
Matt
__________________
Not New to the cub world, but just getting started. Current: XT3 GSX - 60" fabricated deck - spreader - 12cf steel cart - sun shade - 46" front blade IH 129 - 44" deck - ported pump (work in progress) (on radar) 1572 - 60" Haban fabricated Deck - other options unknown IH Tiller for the 129 |
#16
|
||||
|
||||
I Use Black Diamond On Everything But The Rear axle. Use soda for that.
__________________
1872 - 60"haban 54" power angle haban blade '63 Original - restoration project 582 -tiller 147 - leaf duty with bagger. 1811 - Ditch mower 800 - have it just cuz its a 800 |
#17
|
||||
|
||||
I do that by hand with wire wheel and sander/grinder, flap wheel...
__________________
Make the best of each day , Todd Original's Face Lift thread.http://www.onlycubcadets.net/forum/s...ad.php?t=34439 (O) Start to Finish video.https://www.youtube.com/watch?v=GAoUNNiLwKs Wheel Around videohttps://www.youtube.com/watch?v=XUL-m6Bramk They can't all be turn key! |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.