Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > CCC/MTD Cub Cadet built Tractors (GT)
Reload this Page 1641 Fuse Blown, won't run, not ignition switch.
Register FAQ Calendar

Notices

Reply
Page 3 of 5 12 3 45
 
Thread Tools Display Modes
  #21  
Old 04-27-2023, 04:04 PM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
  
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default
Just FYI, not all Vanguards have the fuel shut off solenoid. You can simply remove it and replace it with the factory plug or do as I do on all my Vanguards, remove the solenoid, cut the plunger off and then re-install it. If it's not on the engine it can't cause problems.
Attached Images
File Type: jpg solenoid plug.jpg (9.7 KB, 101 views)
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #22  
Old 04-28-2023, 05:50 PM
malibulvr malibulvr is offline
New Member
  
Join Date: Nov 2009
Location: Lockport, NY
Posts: 28
Default
Quote:
Originally Posted by malibulvr View Post
So I ended up ordering the diode assembly and a new fuse holder, so hopefully this will do it, we will see. Thank you in advance for the time you've taken to help me.
Yes I ordered the diode, and the place sat on it for 3 days, so I called them and they said that it's discontinued and I could not get it. Not sure when they're going to tell me that.
Reply With Quote
  #23  
Old 04-29-2023, 07:54 AM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
  
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default
Cut the plunger of the solenoid and be happy
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #24  
Old 04-29-2023, 09:52 AM
Oak's Avatar
Oak Oak is offline
Senior Moderator
  
Join Date: Jun 2009
Location: Georgia
Posts: 5,183
Default
That's why it's hard to beat Amazon.

https://www.amazon.com/HUABAN-1N5391.../dp/B08MDYRLWD

I think the 1.5 amp will work or if you want bigger these are a 5 amp.
https://www.amazon.com/20-Pieces-SR5...NsaWNrPXRydWU=
__________________
This ain't no hobby....it's an addiction
Reply With Quote
  #25  
Old 04-29-2023, 02:25 PM
ironman's Avatar
ironman ironman is online now
Grand Member
  
Join Date: Sep 2012
Location: Pennsylvania
Posts: 2,289
Default
If anyone is curious,
I did some bench testing on a briggs carb solenoid.
At 12.5 volts it draws 350 milli-amps (a little over 1/3 amp)
Reply With Quote
  #26  
Old 04-30-2023, 03:27 PM
malibulvr malibulvr is offline
New Member
  
Join Date: Nov 2009
Location: Lockport, NY
Posts: 28
Default
So of course I ended up finding one on Amazon LOL. I ran out to the garage, clip the ends off the old diode, j-hooked the diode and remaining ends so I had a good bond with the solder and retention. Threw some sleeving over it, went out to hook it up and of course the fuse immediately blew.
Then I put a larger amp fuse in it this time, 30 amp and the tractor actually ran for about a minute until it blew.

How do I get the solenoid out of the carburetor?

I must still have a short somewhere, this is getting ridiculous LOL. Could the solenoid itself be grounding out?

Today is not the day to be working on this, since it is outside and of course it's raining today.
Attached Images
File Type: jpg 20230430_140017.jpg (19.9 KB, 52 views)
File Type: jpg 20230430_140012.jpg (6.8 KB, 50 views)
Reply With Quote
  #27  
Old 04-30-2023, 03:33 PM
malibulvr malibulvr is offline
New Member
  
Join Date: Nov 2009
Location: Lockport, NY
Posts: 28
Default
So since that diode goes directly to the starter, I'm assuming that once the tractor starts if it was just a wire without a diode it would actually ground out correct? Because I noticed that when I check polarity on the main coming off the solenoid to the starter it shows negative and then changes the positive once the solenoid is activated.
Reply With Quote
  #28  
Old 04-30-2023, 05:28 PM
ironman's Avatar
ironman ironman is online now
Grand Member
  
Join Date: Sep 2012
Location: Pennsylvania
Posts: 2,289
Default
Quote:
Originally Posted by malibulvr View Post
So of course I ended up finding one on Amazon LOL. I ran out to the garage, clip the ends off the old diode, j-hooked the diode and remaining ends so I had a good bond with the solder and retention. Threw some sleeving over it, went out to hook it up and of course the fuse immediately blew.
Can't tell from your pictures but the lead on the end of the diode with the silver band around it should go towards the carb.
If that is not the case, the fuse will blow.
Attached Images
File Type: jpg Screenshot 2023-04-30 162421.jpg (5.5 KB, 46 views)
File Type: jpg Screenshot 2023-04-30 162707.jpg (12.3 KB, 46 views)
Reply With Quote
  #29  
Old 04-30-2023, 09:17 PM
Sam Mac's Avatar
Sam Mac Sam Mac is offline
Administrator
  
Join Date: Feb 2010
Location: Galax VA
Posts: 18,814
Default
Solenoid is on the rear bottom right side of the carb. You should be able to get to it from the top by removing the air cleaner assembly including the base plate. Close the choke to prevent dropping a screw down the carb.
Attached Images
File Type: jpg solenoid.jpg (30.1 KB, 39 views)
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
Reply With Quote
  #30  
Old 04-30-2023, 11:26 PM
malibulvr malibulvr is offline
New Member
  
Join Date: Nov 2009
Location: Lockport, NY
Posts: 28
Default
Quote:
Originally Posted by ironman View Post
Can't tell from your pictures but the lead on the end of the diode with the silver band around it should go towards the carb.
If that is not the case, the fuse will blow.
Silver end is opposite the starter
Reply With Quote
Reply
Page 3 of 5 12 3 45

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 12:24 PM.

www.onlycubcadets.net - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.