PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Quote:
We need to see a pic of this area: It already looks welded to me. Photo-0032.jpg |
#22
|
|||
|
|||
Wish I could see the end where the rod comes out of the cylinder, they look like the cylinders on my Johnson FEL. I just replaced the seals on the bucket cylinders for the same reason about 8 months ago. Remove the push rod dust seal and there's a internal C ring just below it. Remove the C ring and pull the push rod out of the cylinder, the top support bushing will come out with the push rod so it will be easy to check for wear or damage. I took my push rod assembly (with dust seal) to my local Farm Supply parts counter and they matched up the O rings, Teflon O ring spacers and dust seal for my cylinder. I got enough part's to do all four cylinder's for about $25.00 since the lift cylinders were the same dia. It was allot easier than I thought it would be.....Good Luck
|
#23
|
|||
|
|||
Replacement fel cylinders
You might try looking on SURPLUSCENTER.com, you can probably find a good replacement & a pretty good price too. Good luck!
|
#24
|
|||
|
|||
IF you replace the cylinder, replace both. Unless you can find a cylinder with the EXACT same bore and stroke, and mounting at the old one. If not, your loader won't work properly.
|
#25
|
|||
|
|||
These people helped me source some cylinders that are very similar. Just check your measurements and call them, they have more then listed on the site.
http://internationalhydraulicsus.com MIke |
#26
|
||||
|
||||
Why can't you just take a picture of the end of the cylinder where the rod comes out? We are all trying to help you but you have done your best to make it impossible.
__________________
1811 Hydro "Failing to prepare is preparing to fail". |
#27
|
||||
|
||||
Indeed, you probably only need a piston seal.
__________________
1572, 1864 x2, 1810 x2, 1863 & GT1554(Dad's Ole Mowers), 1811,782D, 1872 x2, 782DT(Sold), 3235, 1860, 1772 with 3-point and Turbo. |
#28
|
||||
|
||||
Sorry it took so long could not reply on my kindle for some odd reason. The cylinders are welded and the back two are way bigger then the front two. Back two have no leaks. I found out napa does hoses and the front 4 hoses seem wet. That's where I am going to start. About 20 bucks to replace all 4 but there only 8-10 inchs long.
__________________
108, lights, electric mower and sleeve hitch. |
#29
|
||||
|
||||
hey I got one of these.
__________________
so many tractors, so little money |
#30
|
||||
|
||||
__________________
108, lights, electric mower and sleeve hitch. |
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.