Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > Cub Cadet Engines

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 01-08-2021, 05:48 PM
Jaystang97 Jaystang97 is offline
New Member
 
Join Date: Dec 2020
Location: New York
Posts: 12
Default Engine oil

Changing the oil in my 1810 today and it is super thin and smells like gas! Any ideas of how gas could get in besides it being put in there which I didn't. I inherited the tractor a couple months ago and im going through it doing maintenance.
Reply With Quote
  #2  
Old 01-08-2021, 06:09 PM
Jaystang97 Jaystang97 is offline
New Member
 
Join Date: Dec 2020
Location: New York
Posts: 12
Angry

Muffler is dripping with gas as well!
Reply With Quote
  #3  
Old 01-08-2021, 06:18 PM
mortten mortten is offline
Senior Member
 
Join Date: Sep 2012
Location: Peninsula, Ohio
Posts: 961
Default

Fuel pump leaking fuel into crankcase.
__________________
Doug

Dad's 122 w/42" cast deck, spring assist, lights,weights, rear lift
1250 w/hydraulic lift, lights,weights, spring assist.
50C deck converted to an A with front wheels
44C deck converted to an A with front wheels.
QA-36A
42" blade
Reply With Quote
  #4  
Old 01-08-2021, 06:29 PM
Jaystang97 Jaystang97 is offline
New Member
 
Join Date: Dec 2020
Location: New York
Posts: 12
Default

Not to sound like fool im assuming the fuel pump would be under the T where the lines connect? And had just cleaned the carb any chance a stuck float would allow it to leak in?
Reply With Quote
  #5  
Old 01-08-2021, 06:49 PM
RLause's Avatar
RLause RLause is offline
Senior Member
 
Join Date: Sep 2012
Location: Toledo, Ohio
Posts: 594
Default

If the float leaks, the gas runs into the cylinders past the rings and into the crankcase
__________________
Richard

1979 IH Cub Cadet 782 w/CH20, dual hydraulics, power steering and Cat 0 three point
Reply With Quote
  #6  
Old 01-08-2021, 06:58 PM
ol'George's Avatar
ol'George ol'George is offline
Grand Member
 
Join Date: Oct 2009
Location: MI
Posts: 6,694
Default

Don't run it till you address the problem AND change the oil!!!!!
If you messed with the carb. either you have crud under the needle valve or did something wrong.
Start at the carb first, many times removing/installing the fuel line induces crud under the needle valve.
Also it will smoke like hell after you repair it and start it as the fuel is burning out of the muffler.
Running it without changing the oil, will do damage to the engine
Reply With Quote
  #7  
Old 01-08-2021, 07:51 PM
Jaystang97 Jaystang97 is offline
New Member
 
Join Date: Dec 2020
Location: New York
Posts: 12
Default

I already drained the oil out i left the drain plug out to let everything drip out over night. Yeah I had previously replaced the filter and lines then had an issue with it running so I took the carb off removed the float bowl and cleaned the crud out off the float and all around inside the jets and put the bowl back on. Ill take it back off and make sure nothing is stuck in the needle seat or the float.
Reply With Quote
  #8  
Old 01-09-2021, 10:21 AM
bugeye bugeye is offline
Senior Member
 
Join Date: Jun 2013
Location: Reading, PA
Posts: 292
Default

When I had gas in the oil, I also removed the spark plugs to hopefully allow the cylinder/head to dry. Cranking the engine with the plugs out produced gas on the rag at the plug openings.
__________________
1863, 1864, 48" and 54" mower decks, 54" snow plow, 451 snow blower, TracVac 580
Reply With Quote
  #9  
Old 01-09-2021, 10:54 AM
ol'George's Avatar
ol'George ol'George is offline
Grand Member
 
Join Date: Oct 2009
Location: MI
Posts: 6,694
Default

Quote:
Originally Posted by bugeye View Post
When I had gas in the oil, I also removed the spark plugs to hopefully allow the cylinder/head to dry. Cranking the engine with the plugs out produced gas on the rag at the plug openings.
Normal to do that.

If it was the fuel pump with a ruptured diaphragm , USUALLY it will fill the crankcase with oil. but not the cylinders, But if it gets full enough
it will fill them and then fuel gets pumped into the muffler.
Since you were in the carb it is likely to check that first.
Make sure you take the needle out of the carb and blow the hose connecting elbow out where it connects to the carb both ways, as little cling-ons like to hide there.
if you changed the hoses leading into the fuel pump, also check that they are clean and clear.
Always best to start a hose replacement with blowing out the new length of hose first, then be careful to clean cut a hose, then be careful to put it on the barb taking care to not skin the inner jacket which could birth a cling-on
Reply With Quote
  #10  
Old 01-09-2021, 10:59 AM
darkminion_17's Avatar
darkminion_17 darkminion_17 is offline
Grand Member
 
Join Date: Aug 2010
Location: New Jersey
Posts: 11,093
Default

Those pesky Clingons always end up on Uranus ya know...
__________________
Up to 530 and counting...
I give up updating my profile!
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:22 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.