PLEASE PATRONIZE OUR SPONSORS!
|
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Guess where these came from?
Care to guess where I got these 4 very special bolts from?
__________________
2072 w/60" Haban 982 with 3 pt and 60" Haban 1811 with ags and 50C 124 w/hydraulic lift 782 w/mounted sprayer 2284 w/54" mowing deck |
#2
|
||||
|
||||
Axle tube bolts.
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL |
#3
|
||||
|
||||
__________________
(2) Original, 100, 102, 124, 73, 800, #1 and #2 cart, brinly plows, disk, IH184, IH244, 1948 F Cub |
#4
|
||||
|
||||
You guys are no fun! 3 of the bolts came from axle tubes, the short one came from one of the front transmission braces. Literally there was 1 bolt and the brake rods holding the transmission in--No wonder the driveshaft came flying out and took out the hydraulic lines! I heated the two bolts that were stuck out just enough to grab with vise grips, they screwed right out. The other axle tube bolt was broken off below flush. I heated it 3 times and tried to move it with a punch, no luck. Strapped the housing on the mill table and put a hole in for ease-out, took a little elbow grease but it screwed right out. The fourth bolt was broken halfway down the hole, kind of weird, it screwed out the easiest. All the threads are in great shape. Got to make a big parts order Mon. so I can get this 782 back together. I've got bad wear on the input shaft/charge pump where it hooks to the driveshaft. Plan is to open it up and rebuild the shaft, probably turn or grind it down and then bore and sleeve the mating part to match.
__________________
2072 w/60" Haban 982 with 3 pt and 60" Haban 1811 with ags and 50C 124 w/hydraulic lift 782 w/mounted sprayer 2284 w/54" mowing deck |
#5
|
||||
|
||||
It's hardened so grinder or carbide tool.
Most times easier to pick up a used hydro on ebay. Found an input shaft/bearing there for $15 this past spring. most of those shafts are the same unless they are the splined type |
#6
|
||||
|
||||
Grade 5 bolts on axle housing just bad locktite in aluminum heat it up till it smokes and it will come out
|
#7
|
||||
|
||||
Well that sucks But glad you got the bolts out without any damage.
__________________
Make the best of each day , Todd Original's Face Lift thread.http://www.onlycubcadets.net/forum/s...ad.php?t=34439 (O) Start to Finish video.https://www.youtube.com/watch?v=GAoUNNiLwKs Wheel Around videohttps://www.youtube.com/watch?v=XUL-m6Bramk They can't all be turn key! |
#8
|
||||
|
||||
Thanks for the input guys. Are you guys using Loctite when you put them back together, if so Red or Blue?
__________________
2072 w/60" Haban 982 with 3 pt and 60" Haban 1811 with ags and 50C 124 w/hydraulic lift 782 w/mounted sprayer 2284 w/54" mowing deck |
#9
|
|||
|
|||
Good work.
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.