|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#2
03-30-2013, 11:26 PM
|
||||
|
||||
Quote:
__________________
1782 smoker!!, 169 and parts 128 And a bunch of stuff that fits on the back of them LOL 
|
|
#3
03-31-2013, 06:14 AM
|
||||
|
||||
|
Quote:
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#4
03-31-2013, 08:37 AM
|
||||
|
||||
|
I have no idea what the spec for a D640 is but I can give you some numbers from larger diesels for comparison. the old Detroit 2 strokes you check while the engine is running at idle . naturally aspirated under 500 psi was worn out. they had around a 19-1 comp ratio. the turbo engines were always lower around 425 - 450 . they had around a 16.5 comp ratio. I just checked compression on a International VT365 which is turbo charged and the spec for that was 300-350 cranking. 2 holes were at 275 and those 2 cyl's showed poor on the inj cut out test. The VT365 is the engine Ford called a power stroke. allot of engine's these days they don't give specs for compression just because there's not decent way to check them such as the DT466 HUEI you should be able to make up an adaptor to go into the glow plug hole on the D640.
|
|
#5
03-31-2013, 08:41 AM
|
||||
|
||||
|
I got this off another diesel engine forum I check out on occasion
During work i got a call asking to do a comp. test for my uncle on a little 3 cylinder Kubota engine. I said i would....So i went down and pulled the 3 glow plugs out....Pulled the fuel line off the injection pump. This engine took the same glow plug tester as the duramax did. Added some never seize and went to town on the test... Number one was about 215....I thought to my self. Man thats alittle low for my liking when this thing is Naturally aspirated. I would think its gotta have more compression than that....Well i guested right... Cylinder number 2 was 520 And then Cylinder three was 120 I did the hole 5 minute test again Just to be sure. Needless to say i think the engine needs a rebuild....Smptoms were as told to me: It constantly makes like a....well i guess like a ....Fog coming out of the blow by tube all the time....Engine had about 2500 hours on it. And had little actual oil blow by but had alot of steam.....Uncle and cousin said it has most likely sucked a lot of dirt in its day...So im blameing the dirt on the cylinders being scored or worse.....Just thought you guys might like to hear about what i did today
|
|
#7
03-31-2013, 09:05 AM
|
||||
|
||||
|
I guess I was wrong. This is from a Bota forum.
http://www.orangetractortalks.com/20...tarting-fluid/
__________________
2264 with 54 GT deck 1641 AKA Black Jack with a 402-E Haban Sickle bar mower JD317 dump truck BX2670 with FEL
|
|
#9
03-31-2013, 11:59 AM
|
||||
|
||||
|
allot of the newer diesels have grid heaters in the intake. seen a few trucks come in with rather large burn holes in the air filter from ether. that warning sticker on the hood don't seam to stop people.
|
|
#10
03-31-2013, 03:55 PM
|
||||
|
||||
|
This motor starts hard, idles rough and dogs out under load. I pulled the glow plugs and injectors out today and tested them. Cyl1 has a good plug but the injector drips when not under pressure. Cyl 2 has a good injector but a bad plug. Cyl 3 has a good plug but gets no fuel through the injector at all.
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
