|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
05-22-2017, 04:03 PM
|
|||
|
|||
18hp B&S Vanguard in 782
Looking for any information about wiring a 18hp B&S vanguard into a 782.
I have a 782 that did not have an engine and found one that already had been in a 682. The only information the guy I purchased the engine from said all I needed was a 6 prong ignition switch and make the drive shaft about 1 inch longer. The motor mounted right in and I have a switch ordered but not sure how to wire the new switch to the vanguard or what changes I need to make to the current wiring harness. I don't think this was a kit when he purchased. I have a red wire coming off of the regulator, another red wire that goes into the shroud, and a white wire that is screwed to white plastic on shroud. any information is appreciated. Thank Scott 
|
|
#2
05-24-2017, 03:10 PM
|
|||
|
|||
|
First, welcome to OCC......
 I can help you BUT....I need the B&S Model and Type number before I dive into this. Further, I may take a couple of days before I can draw up a diagram. If that suits you, then let me know.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
#3
05-24-2017, 10:15 PM
|
||||
|
||||
|
I've done this a few times (wiring a vanguard into another tractor) but never wrote it down. Basically, the red wire from the regulator is the regulated DC charge, the white wire screwed to the plastic is the kill switch, and the other red wire is the fuel solenoid. You're missing the solenoid wire to engage the solenoid to start it, and the lights.
I don't remember off the top of my head which ones go where on the ignition switch, but it isn't too hard to figure out with the right documentation/pictures. 
|
|
#5
05-25-2017, 03:53 PM
|
|||
|
|||
|
356477-XXXX What is X...???
 What is the Chassis Serial Number for the 782...?? 
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
#6
05-25-2017, 06:34 PM
|
|||
|
|||
|
Here are pictures of the data plates on cub cadet and also the vanguard motor I am putting in
356447-0079-F1 is the entire number on the data plate for vanguard engine 143782399 model for 782 serial number2050601U714252 Thanks
|
|
#7
05-25-2017, 06:59 PM
|
|||
|
|||
|
Thanks,
I'll get the B&S Diagram.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
#10
05-26-2017, 02:00 PM
|
|||
|
|||
|
Diagram completed and sent.
__________________
[B]Roland Bedell[/B] CC Models: 100, 105, 1450, 782, (2) 784, & 2072 [SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
