Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Everyone, we have 2 new Sponsors!
Machtech Direct and P&K Cub Cadet (See Links above)


Go Back   Only Cub Cadets > Cub Cadets > Cub Cadet Engines > Kohler Engines

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 08-21-2013, 03:13 PM
cubfixer's Avatar
cubfixer cubfixer is offline
Senior Member
 
Join Date: Sep 2012
Location: Virginia
Posts: 651
Default K301 Rod lockwashers

I bought my 124 for parts, until I was able to crank it up and run it after setting the points and cleaning out the sediment bowl. This tractor looks like it was run hard and not taken care of. Much rust and nails instead of cotter pins. The tractor ran OK, but had the greatest engine vibration I have ever seen. It was strong and didn't smoke.

Anyway, I ran the engine low on oil while pushing dirt (should have checked oil level every two hours or so), and it started smoking oil smoke big time. I have now opened up the engine, checked rod bearing (like new - no wear at all), honed the cylinder, re-ringed it, and put the piston back into the block. I am putting the rod cap on, and I see that the rod bolts have TWO washers on each bolt, a lock washer and a flat washer. According the the manual, the K301 should use just a flat washer (no lock washer). I am sure that this engine must have been gone thru just before i got it (perfect crank, bearings like new, new connecting rod probably). If the PO did use flat washers AND lock washers, that might explain why it is out of balance.

My question is: do I put the two pair of washers back on the rod bolts, use the flat washers only or use the lock washers only. Has anyone seen a K301 engine with two washers on each rod bolt?
__________________
John

Proud Owner of a Model 100 and a Model 124.
A homemade cart, 2 x 42" mower decks, a 38" deck,
a 42" front NF blade, and a lawn sweeper!
Reply With Quote
  #2  
Old 08-21-2013, 07:57 PM
dvogtvpe's Avatar
dvogtvpe dvogtvpe is offline
Grand Member
 
Join Date: Oct 2011
Location: Campbellsport Wisconsin
Posts: 1,585
Default

I've seen them both ways. with 1 thick flat washer or a thin flat washer and a lock washer that is if it has bolts. studs its just a nut with the built in washer. that nut has a lower reuse torque. a couple lock washers won't throw them out of balance. they are pretty poor with balance to start with. I think Kohler felt somewhat close was good enough
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:43 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.