|
PLEASE PATRONIZE OUR SPONSORS!
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
05-08-2024, 05:50 PM
|
|||
|
|||
Cub cadet 108 transmission noise
Hello everyone. I am a new member, I hope i'm posting right. Well I have a cub cadet 108 that has input bearing noise at front of transmission ( 3 speed manual ) My question is, can I replace the bearing with out removeing transmission from tractor ? Do I just have to remove drive shaft only ? , and how do I get drive shaft out with out removeing motor ? I've removed driveshafts from other cubs, but on the 108 I can't get it out. It does not have a creeper gear. Thanks in advance to everyone who answers J. C.
|
|
#2
05-16-2024, 11:29 AM
|
|||
|
|||
|
I'm also a NEWB working on a CC108 Transmission.
I found this video helpful as it confirmed some of what I suspected. Moreover he addresses a loose spline bearing. while it may not be a solution to your situation. It's all I got for you... https://www.youtube.com/watch?v=ijcOj3zVkEo Daryl MN
|
|
#3
05-16-2024, 01:31 PM
|
||||
|
||||
|
IF you're positive that the noise is at the input, this is the area that you are talking about. It is called the reduction drive.
The picture of the transmission shows where it resides. As you can see, that whole flat panel must be removed then the shaft just pulls out. In my opinion, you can take the front panel off the front of the transmission without removal from the tractor. But of course the drive shaft will have to be removed, which will be the PITA part.
|
|
#4
05-17-2024, 09:19 AM
|
|||
|
|||
|
Thank you very much Ironman. That is exactly what I was hopeing for.
Jim Colson
|
|
|
|
Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.
MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.
This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC
All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.
Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.
Linear Mode
