Just looked at the install directions for the valve kit for the Cyclops and they only mention 1 O-Ring on each side of that adapter, maybe the 3000's are different. Can't say because I have never seen one. :bigthink:

The 3k tractors only require 1 ring per side also. I will get the adapter and some rings out to you this week Sam.

I would be interested a pair of them as well.

Don

Big thanks for this post Just checked pricing on a bunch of seals and gaskets I need for my 1782, www.cubcadetpartsnmore.com had better pricing than every other place I looked at. :beerchug:

SamMac, I would like one of those adapters also please.

The diagram for the 365 3-point hitch shows a 721-0492 oring backup in addition to the 721-3021 oring on each side of the adapter.

2182 dual hydrualics
 

Hi Sam,

I would like whatever is needed to convert my 1882 as well. If you can please PM me when your ready.

Thanks Mike

Hi Guys,

I am trying to do this exact same project to a 2084. Just picked up a plow for it and want to make it fully hydraulic. Any help would be great.

Sam - you don't happen to have another one of those valves laying around do you? I see I just missed one on eBay a few days ago :-(

Also, this part you are having made is what stacks these valves together, right? If so, I am in for 2 of them!

Thanks guys!

I looked at the 3000 blade angle kit that required adding a valve. That is where I got the opinion that it needed both o rings and back up rings. I may have been wrong, but only wanted to do it once.

SamMac- I just re-read these posts and realized I should have asked you to reserve 2 of the adapters for me rather than 1.
Thanks!

Sam Mac or anyone else, can you confirm that the part number I need for and additional hydraulic valve for my cyclops SGT, model 2084 is 717-3308a?

Then I will just need to make a handle to operate the valve, correct?

Thanks for the help guys!