1806 Wiring Diagram
 

Putting a magnum in my 982 from an 1806, does anyone have a wiring diagram for this?

Joe

This would definitely be a "Custom" drawn diagram. I'll see what I can do later today.

Thank you very much Roland.
FYI...there is no wiring harness in the 982 and I have the harness out
of the1806, I just need to know where to hook up the terminals.
Sorry that I wasn't clear. Both seem to be very similar.

OK....need add'l information.

a) What is the Chassis Serial Number of your 982?

b) What options does your 982 have (ie: rear PTO)?

Chassis serial number 2050592U674662
No rear PTO no other options other than the dual hydraulics.

Joe

GREAT... you have a IH built tractor.

One last thing. Are you going to use the Ignition Switch from the 1806 or the 982..???

Will use the 1806 switch

Bumped to remove post

If you can be patient, I can do this for you. If you are in a hurry, then maybe some one else can jump on it.

Sounds to me like a wiring diagram from a 782 is what you're looking for. Safety options were all the same, and that's basically what you're making. Trust me - I just put an 18 Mag in my 982 and used my 784 for a basis. Right, wrong, or indifferent, it runs. I guess that the later model 18 Mags have the oil pressure sensor - that might throw a wrench in.