convert snowplow for 1812 to fit 2072
 

Has anyone tried this? Can it be done and how much trouble would it be?

If you are any good with metal, should be no problem.

Does anyone have a picture of the frame for a snowplow on a super?

The frame on the supers is longer, but not wider. I don't see any reason why you couldn't just lengthen the braces that run to the back. The blades for the supers were a completely different design. Looking at those wouldn't help you much. Unless you want to make a whole new sub-assembly. :bigthink:

cut the slotted ears off the back end of the blade frame and add a piece to lengthen the frame [around 4 inches if I remember correctly] and weld the ears back on wouldn't hurt to plate the frame where it is spliced to reinforce it and add a cross brace between the frame ears...

I set the plow under the 2072 looks like it will be an easy modification...