Pulling axles on an 1812
 

never done this before , whats the best way to remove a rear axle from an 1812 to replace the seal, thnx in advance

Put it on jack stands, drain the oil, remove the rear cover, wheels, brakes, then pop the c-clips in the center of the diff and out they come. Clean everything up, pull the old seals and replace. Then put it back together.

Good time to suction to water out of the axle tubes while you have the axles out.

thanks much

It's all explained in the service manual starting on page 3-25
http://www.onlycubcadets.net/forum/s...ad.php?t=25397