I need some help
 

Hi there, i need some help. i own a few cubs, but am having some issues with one in particular. i have a 122, beautiful, but can not get it to start. it will crank over, but thats it. ive replaced the coil, condenser, points, battery, spark plug and coil wire. ive tested all the wiring, and they all seem to be good. i have noticed im not getting spark to my plug. but its a good plug. also, on my points, no spark...any suggestions would help me dearly!!!

this is my 122 that im having issues with...

Ignition switch? Also are your points gap properly?

I put this in your other thread, didn't know about this one.


Sometimes you need to "deglaze" new points. However, first, Buy a cheap 12 volt test light and test for positive at positive post of coil during start. If present, next step is, While starting, probe negative side of coil while starting, test light should flash. If it stays on constant, points aren't closing properly, if light is not on at all, coil is open or points aren't opening properly and coil needs to be replaced/points adjusted. Let us know your findings.

Btw how did you set points? Need to use "static timing" method and not just gap them.

Next step for sure. This should tell you all you need to know.

What they said, plus the ignition switch may be faulty also,BTDT

thank you all
 

thanks everyone. i will start tomorrow on all ideas given. im hoping to find the problem and hear this thing run, it hasnt ran since my father purchased it for me for a mothers day gift...