1782 issues
 

Found a small leak on my injection pump. Anyone know where I can find the correct seal or know a way to fix it? In the pic its leaking in between the plate with the security torx screws and the pump.

There is no seal or gasket there. Only steel shims. That's how you adjust the timing on a Kubota. Make sure the screws are torqued to spec. If a leak is bad and continues, you can remove and clean the shims. DO NOT put silicone on them. That will change the thickness and change the timing.

Thanks for the info. I was hoping you'd chime in...I'll try that once I get it back together...