Will a 109 run a Haban sickle bar?

[JLM78]

Will a 109 handle A sickle bar ? Any one have A rear mount for the back of the tractor I will put A add in the wanted add

[J-Mech]

Will it run it.... ?.... Like as in, does it have enough HP? Yes. But it mounts on the side. Or do you want a rear 3pt? What do you mean a rear mount?

[JLM78]

this is what Am looking for in the box

[Sam Mac]

Here are a couple pics. Doesn't look like it would be too hard to make one. I'm also missing this part on my Haban sickle but it's on a 1641 so I need to fab up something a little different. At the moment I'm using a tie down strap, just a bit Red Neck but it works.

[hdsdcouple]

well, Haban didn't make a rear mount pto driven sickle bar. The problem I see if you want to convert a mid mount Haban to a rear PTO driven is that the rear PTO will not spin fast enough. but I could be wrong and I often am. There are a couple of companies that make a Hydro powered sickle (no belts) might be a better idea.

I am not sure why you would rather have a rear mount than a mid mount. the point of a mid mount is so you don't have to keep looking backwards. I had a tow behind sickle, key word had.

just my opinion

[hdsdcouple]

lol I read that wrong. I will go out and look in the pile and see if I have one.

[JLM78]

Originally Posted by hdsdcouple

lol I read that wrong. I will go out and look in the pile and see if I have one.

thanks for looking

[Bsmith]

Haban did make a rear mount cat 0 sickle bar mower. They were the 440 series.

[hdsdcouple]

ya, I was referring to his 109. sorry for the mistake there.