Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 04-15-2015, 08:56 PM
Tyler_1066 Tyler_1066 is offline
New Member
 
Join Date: Mar 2015
Location: Kentucky
Posts: 1
Default Need help please

I have a cub 128 and my rock shaft arms are not level. in other words, my deck is unlevel becuase my passenger side arm is lower then the arm on the left so the deck is 3inches high on the left and 1 inch high on the right when all the way lifted up. The deck is adjusted evenly its just that right arm that hangs lower then the left side.

So i took the middle cover off and noticed the roll pins in the shaft. they are both in and secure. the right roll pin is signinficanlty larger then the left side though. the left roll pin is lined up directly top center while the right arm is not top center actually leaning more towards the front of the tractor.

Should i knock the pin out and see if i cn adjust the arms back to level?
Reply With Quote
  #2  
Old 04-15-2015, 09:24 PM
Alvy's Avatar
Alvy Alvy is offline
Grand Member
 
Join Date: Jul 2012
Location: Winter Haven, FL
Posts: 3,567
Default

I would yes. Jut because you see the roll pin doesn't mean the middle isn't broken and clocked differently, I've seen it a lot. Although there's a chance that side is bent I would go there first
__________________
(2) Original, 100, 102, 124, 73, 800, #1 and #2 cart, brinly plows, disk, IH184, IH244, 1948 F Cub
Reply With Quote
  #3  
Old 04-15-2015, 09:28 PM
Yosemite Sam Yosemite Sam is offline
Grand Member
 
Join Date: Mar 2009
Location: Medora, IL
Posts: 3,866
Default

Welcome to OCC Tyler,

Chances are you have a sheared spiral pin in one of the arms. It will be difficult to get out, you must line the holes up and then drive the broken pieces out.

Good Luck with it.
__________________
More IH Cub Cadet Parts RIGHT HERE
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:22 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.